Timberclean by Urethane Coatings - Polyurethane Specialists Since 1979

Timberclean

TDS  |  MSDS

A mild acid solution formulated to restore the natural colour of timber by removing mould, dirt and stains.

USES:

URETHANE COATINGS TIMBER CLEAN has been developed to restore the natural colour of exterior timber by removing mould, mildew, dirt and tannin stains  

URETHANE COATINGS TIMBER CLEAN is suitable for cleaning exterior timber structures including, decking, outdoor furniture, unpainted weather boards, door jams, window frames, fences, steps, and railings.

PREPARATION:

Clear working area, sweep surface clean and thoroughly wash down with water.

THINNING:

Measure one (1) part URETHANE COATINGS TIMBER CLEAN and add to three (3) parts water, mix and stir thoroughly. If timber is badly weathered or stains are particularly difficult to remove, increase the proportion of Timber Clean in the mix ratio - for very stubborn stains use TIMBERCLEAN without thinning.

APPLICATION:

Wet timber surface with water. Apply with a stiff bristle brush and scrub surface. Allow 20-30 minutes for TIMBER CLEAN to soak into the timber then wash off with high pressure water. Ensure timber is completely dry before coating with URETHANE COATINGS NATURAL DECKING OIL.

COVERAGE:

4-6 m² per litre of mixed Timber Clean (1 litre of Timber Clean will make a solution to clean up to 24 m²).

CLEAN UP:

Clean brushes and equipment with water.

SHELF LIFE:

TIMBER CLEAN is best if used within 24 months of manufacture (refer to batch number on label), when stored in unopened containers under normal conditions of temperature and humidity.

SAFETY DIRECTIONS:

Use this material in well ventilated conditions. Prevent skin contact by wearing impervious gloves. Avoid breathing of vapour as it may cause lung irritation. May irritates skin and eyes. Keep container closed when not in use. In case of spillage, absorb into dry sand or dirt, then remove from work area and complete disposal in responsible manner.

FIRE:

Non Combustible.

FIRST AID:

If affected by inhalation of vapour, remove to fresh air. If breathing difficulty persists or occurs later, consult a doctor and have label ready. If swallowed, do NOT induce vomiting. Give water or milk.

CONTACT DOCTOR OR POSIONS INFORMATION CENTRE Australia 131126.

In case of eye contact, flush immediately with water for fifteen minutes and call a doctor. In case of skin contact, remove contaminated clothing and wash skin with soap and water.